The Culvert Creep was specially designed for locating, snaking and thawing culverts. It will eliminate the need to thaw grader banks of ice and snow to LOCATE the culvert. Operator simply inserts a crawler jet into the end of the Culvert Creep and it snakes into the culvert every time, thus beginning the thawing process.
- Locate and thaw culverts
- Reduce service costs
- Eliminate safety hazards
- Easy installation, all culvert sizes
- Rigid construction
- High visibility
The Culvert Creep will eliminate the need to thaw grader banks of ice and snow to LOCATE the culvert! It is designed at a 45 degree angle to keep it away from the grader, while allowing easy thawing access. Operator simply inserts a crawler jet into the end of the Culvert Creep and it snakes into the culvert every time, thus beginning the thawing process.
Older, well established roads are a prime candidate for the Culvert Creep. Over time, ditches have filled in. Some culverts can be 1 - 3 feet below grade. These culverts can be especially hard to locate because of their depth. Hours can be spent searching for the culvert, and often to even locate it, operators must reach into the cold water and ice to insert a crawl jet. This creates a safety hazard, where the operator can be cut with sharp metal and ice.
With a Culvert Creep, this job becomes much more efficient, safer and far less expensive.
